[PATCH v4 0/8] ARM: davinci: complete the conversion to using the reset framework

[Sekhar Nori]

Hi Suman,

On Tuesday 27 March 2018 06:12 AM, Suman Anna wrote:
> I tried booting your tree [3] on the OMAPL138-LCDK board. I am using
> NFS, and I am unable to get to the console. I don't have any issues
> booting latest -next branch (next-20180326) which only has the reset and
> clock driver related changes.
> 
> Here's the log towards the end of the boot..
> ---
> pinctrl-single 1c14120.pinmux: 160 pins, size 80
> Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled
> console [ttyS2] disabled
> 1d0d000.serial: ttyS2 at MMIO 0x1d0d000 (irq = 61, base_baud = 8250000)
> is a TI DA8xx/66AK2x
> console [ttyS2] enabled
> brd: module loaded
> libphy: Fixed MDIO Bus: probed
> davinci_mdio 1e24000.mdio: davinci mdio revision 1.5, bus freq 2200000
> davinci_mdio 1e24000.mdio: no live phy, scanning all
> davinci_mdio: probe of 1e24000.mdio failed with error -5
> i2c /dev entries driver
> <nothing after this>

This is because of a bug in bootloader PLL configuration which got
uncovered only with CCF conversion. The bootloader that comes
pre-flashed with the board or the latest U-Boot master should work fine.

Here is the log with latest U-Boot master:
https://pastebin.ubuntu.com/p/HkwY9g4YDc/

Thanks,
Sekhar