[PATCH v3 01/11] mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg

[Adrian Hunter]

On 07/03/18 15:20, Kishon Vijay Abraham I wrote:
> sdhci_omap_config_iodelay_pinctrl_state() requires caps and caps2 to be
> initialized (speed mode capabilities like UHS/HS200) before it is
> invoked. While mmc_of_parse() initializes caps/caps2 if capabilities is
> populated in device tree, it will remain uninitialized for capabilities
> obtained from SDHCI_CAPABILITIES register.
> Fix sdhci_omap_config_iodelay_pinctrl_state() to be used even while
> getting the capabilities from SDHCI_CAPABILITIES register by invoking
> sdhci_setup_host() before sdhci_omap_config_iodelay_pinctrl_state().
> 
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
> ---
>  drivers/mmc/host/sdhci-omap.c | 14 +++++++++-----
>  1 file changed, 9 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci-omap.c b/drivers/mmc/host/sdhci-omap.c
> index 1456abd5eeb9..3cce30584d2f 100644
> --- a/drivers/mmc/host/sdhci-omap.c
> +++ b/drivers/mmc/host/sdhci-omap.c
> @@ -916,10 +916,6 @@ static int sdhci_omap_probe(struct platform_device *pdev)
>  		goto err_put_sync;
>  	}
>  
> -	ret = sdhci_omap_config_iodelay_pinctrl_state(omap_host);
> -	if (ret)
> -		goto err_put_sync;
> -
>  	host->mmc_host_ops.get_ro = mmc_gpio_get_ro;
>  	host->mmc_host_ops.start_signal_voltage_switch =
>  					sdhci_omap_start_signal_voltage_switch;
> @@ -930,7 +926,15 @@ static int sdhci_omap_probe(struct platform_device *pdev)
>  	sdhci_read_caps(host);
>  	host->caps |= SDHCI_CAN_DO_ADMA2;
>  
> -	ret = sdhci_add_host(host);
> +	ret = sdhci_setup_host(host);
> +	if (ret)
> +		goto err_put_sync;
> +
> +	ret = sdhci_omap_config_iodelay_pinctrl_state(omap_host);
> +	if (ret)
> +		goto err_put_sync;
> +
> +	ret = __sdhci_add_host(host);
>  	if (ret)
>  		goto err_put_sync;

if __sdhci_add_host() fails, then sdhci_cleanup_host() needs to be called to
free resources allocated by sdhci_setup_host().