[PATCH v2 3/6] ARM: dts: omap5: add support for control module wkup pad config

[Peter Ujfalusi]

From: Tero Kristo <t-kristo at ti.com>

The pad configuration area under control module wkup has some miscellaneous
config registers, that are not pinmux related. Add a separate area for
these, and add support for syscon / clocks under this new area.

Signed-off-by: Tero Kristo <t-kristo at ti.com>
Tested-by: Peter Ujfalusi <peter.ujfalusi at ti.com>
---
 arch/arm/boot/dts/omap5.dtsi | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
index 511606c17a04..732b61a0e990 100644
--- a/arch/arm/boot/dts/omap5.dtsi
+++ b/arch/arm/boot/dts/omap5.dtsi
@@ -287,6 +287,28 @@
 				pinctrl-single,register-width = <16>;
 				pinctrl-single,function-mask = <0x7fff>;
 			};
+
+			omap5_scm_wkup_pad_conf: omap5_scm_wkup_pad_conf at cda0 {
+				compatible = "ti,omap5-scm-wkup-pad-conf",
+					     "simple-bus";
+				reg = <0xcda0 0x60>;
+				#address-cells = <1>;
+				#size-cells = <1>;
+				ranges = <0 0xcda0 0x60>;
+
+				scm_wkup_pad_conf: scm_conf at 0 {
+					compatible = "syscon", "simple-bus";
+					reg = <0x0 0x60>;
+					#address-cells = <1>;
+					#size-cells = <1>;
+					ranges = <0 0x0 0x60>;
+
+					scm_wkup_pad_conf_clocks: clocks at 0 {
+						#address-cells = <1>;
+						#size-cells = <0>;
+					};
+				};
+			};
 		};
 
 		ocmcram: ocmcram at 40300000 {
-- 
Peter

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki