[PATCH v5 0/2] add support for Socionext SynQuacer I2C controller

[Ard Biesheuvel]

On 2 March 2018 at 08:31, Ard Biesheuvel <ard.biesheuvel at linaro.org> wrote:
> Add a binding and a driver for the I2C IP found in the Socionext SynQuacer
> SoC, which is essentially a rebranded version of the Fujitsu F_I2C controller.
>
> I think this is good to go now. Wolfram?
>

Ping?

> v5:
> - add Rob's ack to #1
> - drop unnecessary 'platform_set_drvdata(pdev, NULL)' in remove path (#2)
>
> v4:
> - clarify binding that only a single interrupt specifier is expected (#1)
> - check return value of clk_prepare_enable() on probe path (#2)
> - add Andy's R-b to patch #2
>
> v3:
> - incorporate more of Andy's review comments (#2), especially regarding the
>   bus speed and clock source handling for ACPI
> - patch #1 unchanged.
>
> v2:
> - incorporate Andy's review comments (#2)
> - patch #1 unchanged.
>
> Ard Biesheuvel (2):
>   dt-bindings: i2c: add binding for Socionext SynQuacer I2C
>   i2c: add support for Socionext SynQuacer I2C controller
>
>  Documentation/devicetree/bindings/i2c/i2c-synquacer.txt |  29 +
>  drivers/i2c/busses/Kconfig                              |  10 +
>  drivers/i2c/busses/Makefile                             |   1 +
>  drivers/i2c/busses/i2c-synquacer.c                      | 791 ++++++++++++++++++++
>  4 files changed, 831 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/i2c/i2c-synquacer.txt
>  create mode 100644 drivers/i2c/busses/i2c-synquacer.c
>
> --
> 2.11.0
>