[PATCH 2/2] serial: stm32: update interrupt initialization

[Rob Herring]

On Wed, Feb 28, 2018 at 10:51:17AM +0000, Bich HEMON wrote:
> For each port, get each IRQ using its specific name instead of its index.
> 
> Signed-off-by: Bich Hemon <bich.hemon at st.com>
> ---
>  drivers/tty/serial/stm32-usart.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
> index 0fa735b..5c85cbc 100644
> --- a/drivers/tty/serial/stm32-usart.c
> +++ b/drivers/tty/serial/stm32-usart.c
> @@ -680,8 +680,8 @@ static int stm32_init_port(struct stm32_port *stm32port,
>  	port->flags	= UPF_BOOT_AUTOCONF;
>  	port->ops	= &stm32_uart_ops;
>  	port->dev	= &pdev->dev;
> -	port->irq	= platform_get_irq(pdev, 0);
> -	stm32port->wakeirq = platform_get_irq(pdev, 1);
> +	port->irq	= platform_get_irq_byname(pdev, "event");
> +	stm32port->wakeirq = platform_get_irq_byname(pdev, "wakeup");

This change is not necessary. The interrupts should be at fixed indices.

>  	stm32port->fifoen = stm32port->info->cfg.has_fifo;
>  
>  	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> -- 
> 1.9.1