[PATCH 3/3] pinctrl: qcom: Don't allow protected pins to be requested

[Timur Tabi]

On 01/22/2018 07:55 AM, Timur Tabi wrote:
> 
> Just FYI, I'm still going to have to parse "gpios" in my 
> pinctrl-qdf2xxx.c driver, even though you're also parsing it here. 
> That's because I need to make sure that the msm_pingroup array only 
> contains "approve" addresses in its ctl_reg fields.

Also, my patch

[PATCH 3/3] [v7] pinctrl: qcom: qdf2xxx: add support for new ACPI HID 
QCOM8002

Applies on top of your patches as-is.

Also, what about

[PATCH 1/3] [v2] Revert "gpio: set up initial state from .get_direction()"

I think you still need this patch.

-- 
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm
Technologies, Inc.  Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.