[RFC PATCH 2/2] gpio: provide a consumer when requesting a gpio

[Ludovic Desroches]

On Thu, Jan 18, 2018 at 11:30:00AM +0100, Linus Walleij wrote:
> On Mon, Jan 15, 2018 at 5:24 PM, Ludovic Desroches
> <ludovic.desroches at microchip.com> wrote:
> 
> > It can be useful for the pinmuxing layer to know which device is
> > requesting a GPIO. Add a consumer variant for gpiod_request to
> > reach this goal.
> >
> > GPIO chips managed by pin controllers should provide the new
> > request_consumer operation. They can rely on
> > gpiochip_generic_request_consumer instead of
> > gpiochip_generic_request.
> >
> > Signed-off-by: Ludovic Desroches <ludovic.desroches at microchip.com>
> 
> I think we need to think over what is a good way to share ownership
> of a pin.
> 
> Russell pointed me to a similar problem incidentally and I briefly looked
> into it: there are cases when several devices may need to hold the
> same pin.
> 
> Can't we just look up the associated gpio_chip from the GPIO range,
> and in case the pin is connected between the pin controller and
> the GPIO chip, then we allow the gpiochip to also take a
> reference?
> 

It's the probably the way to go, it was Maxime's proposal and Andy seems
to agree this solution.

> I.e. in that case you just allow gpio_owner to proceed and take the
> pin just like with a non-strict controller.
> 
> Yours,
> Linus Walleij

Regards

Ludovic