[PATCH v3 4/4] ARM: dts: bcm2837-rpi-3-b: add GPIO expander

Stefan Wahren stefan.wahren at i2se.com
Wed Jan 17 00:30:09 PST 2018


Hi Linus,
hi Eric,


Am 16.01.2018 um 13:45 schrieb Baruch Siach:
> Add a description of the RPi3 GPIO expander that the VC4 firmware controls.
>
> Signed-off-by: Baruch Siach <baruch at tkos.co.il>
> ---
> v3:
>    * List GPIO names one per line.
>
> v2:
>    * Move GPIO expander node out of the soc container
>    * Rename compatible string
>    * Add gpio-line-names property
> ---
>   arch/arm/boot/dts/bcm2837-rpi-3-b.dts | 16 ++++++++++++++++
>   1 file changed, 16 insertions(+)
>
> diff --git a/arch/arm/boot/dts/bcm2837-rpi-3-b.dts b/arch/arm/boot/dts/bcm2837-rpi-3-b.dts
> index b44b3b5af00d..8cd93425ffe3 100644
> --- a/arch/arm/boot/dts/bcm2837-rpi-3-b.dts
> +++ b/arch/arm/boot/dts/bcm2837-rpi-3-b.dts
> @@ -23,6 +23,22 @@
>   			gpios = <&gpio 47 0>;
>   		};
>   	};

i noticed that this patch conflicts with my patch ("ARM: dts: bcm283x: 
Use GPIO polarity defines consistently") in linux-next.

How should we proceed?

> +
> +	expgpio: gpio-expander {
> +		compatible = "raspberrypi,firmware-gpio";
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +		firmware = <&firmware>;
> +		gpio-line-names = "BT_ON",
> +				  "WL_ON",
> +				  "STATUS_LED",
> +				  "LAN_RUN",
> +				  "HPD_N",
> +				  "CAM_GPIO0",
> +				  "CAM_GPIO1",
> +				  "PWR_LOW_N";
> +		status = "okay";
> +	};
>   };
>   
>   /* uart0 communicates with the BT module */




More information about the linux-arm-kernel mailing list