[PATCH v3 2/4] dt-bindings: gpio: add raspberry pi GPIO expander binding

[Baruch Siach]

The Raspberry Pi 3 GPIO expander is controlled by the VC4 firmware over
I2C. The firmware mailbox interface allows the ARM core to control the
GPIO lines.

Signed-off-by: Baruch Siach <baruch at tkos.co.il>
---
v3:
  * Rename node name.

v2:
  * Rename compatible string to raspberrypi,firmware-gpio
---
 .../bindings/gpio/raspberrypi,firmware-gpio.txt    | 24 ++++++++++++++++++++++
 1 file changed, 24 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt

diff --git a/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt b/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt
new file mode 100644
index 000000000000..936dc59eba12
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt
@@ -0,0 +1,24 @@
+Raspberry Pi GPIO expander
+
+The Raspberry Pi 3 GPIO expander is controlled by the VC4 firmware. The
+firmware exposes a mailbox interface that allows the ARM core to control the
+GPIO lines on the expander.
+
+Required properties:
+
+- compatible : Should be "raspberrypi,firmware-gpio"
+- gpio-controller : Marks the device node as a gpio controller
+- #gpio-cells : Should be two.  The first cell is the pin number, and
+  the second cell is used to specify the gpio polarity:
+  0 = active high
+  1 = active low
+- firmware : Reference to the RPi firmware device node
+
+Example:
+
+expgpio: gpio-expander {
+	compatible = "raspberrypi,firmware-gpio";
+	gpio-controller;
+	#gpio-cells = <2>;
+	firmware = <&firmware>;
+};
-- 
2.15.1