[PATCH v2 1/4] ARM: bcm2835: sync firmware properties with downstream

[Baruch Siach]

Hi Linus,

On Tue, Jan 16, 2018 at 10:57:32AM +0100, Linus Walleij wrote:
> On Sat, Jan 13, 2018 at 10:57 AM, Stefan Wahren <stefan.wahren at i2se.com> wrote:
> >> Baruch Siach <baruch at tkos.co.il> hat am 11. Januar 2018 um 20:44 geschrieben:
> >>
> >> Add latest firmware property tags from the latest Raspberry Pi downstream
> >> kernel. This is needed for the GPIO tags, so we can control the GPIO
> >> multiplexor lines.
> >>
> >> Signed-off-by: Baruch Siach <baruch at tkos.co.il>
> >
> > Acked-by: Stefan Wahren <stefan.wahren at i2se.com>
> >
> > Maybe this is obvious, but patch #3 depends on this change so no cherry-picking allowed.
> 
> I will save this for after the merge window as it feels now.
> 
> But as far as I have the right ACKs I can put it in the GPIO tree.
> 
> Baruch: can you resend the series with all ACKs and push me
> to apply it all in the GPIO tree if you're fine with this approach?

I plan to send another revision of this series later today to address Stefan's 
comments on this one. Once Stefan and/or Eric ack the entire series, I'm fine 
with you taking it through the GPIO tree if it is OK with the BCM2835 
maintainers.

baruch

-- 
     http://baruch.siach.name/blog/                  ~. .~   Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
   - baruch at tkos.co.il - tel: +972.52.368.4656, http://www.tkos.co.il -