[PATCH 02/14] mmc: mmci: Don't pretend all variants to have MCI_STARBITERR flag

[Ulf Hansson]

On 12 January 2018 at 13:15,  <patrice.chotard at st.com> wrote:
> From: Patrice Chotard <patrice.chotard at st.com>
>
> This patch prepares for supporting the STM32 variant that
> has no such bit in the status register.
>
> Signed-off-by: Andrea Merello <andrea.merello at gmail.com>
> Signed-off-by: Patrice Chotard <patrice.chotard at st.com>
> ---
>  drivers/mmc/host/mmci.c | 16 ++++++++++++++--
>  1 file changed, 14 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
> index 3125dc0..7e56f85 100644
> --- a/drivers/mmc/host/mmci.c
> +++ b/drivers/mmc/host/mmci.c
> @@ -83,6 +83,8 @@
>   * @qcom_dml: enables qcom specific dma glue for dma transfers.
>   * @reversed_irq_handling: handle data irq before cmd irq.
>   * @mmcimask1: true if variant have a MMCIMASK1 register.
> + * @start_err: true is the variant has STARTBITERR bit inside MMCISTATUS
> + *            register.
>   */
>  struct variant_data {
>         unsigned int            clkreg;
> @@ -113,6 +115,7 @@ struct variant_data {
>         bool                    qcom_dml;
>         bool                    reversed_irq_handling;
>         bool                    mmcimask1;
> +       bool                    start_err;

To be consistent with how we implement support for similar variant
variations, I would prefer to have this being a u32. Something along
the lines of how the "busy_detect_flag" is being used.

Otherwise this looks good to me.

[...]

Kind regards
Uffe