[1/5] clk: divider: read-only divider can propagate rate change

[David Lechner]

On 01/05/2018 11:09 AM, Jerome Brunet wrote:
> When a divider clock has CLK_DIVIDER_READ_ONLY set, it means that the
> register shall be left un-touched, but it does not mean the clock
> should stop rate propagation if CLK_SET_RATE_PARENT is set
> 
> This is properly handled in qcom clk-regmap-divider but it was not in
> the generic divider
> 
> Fixes: e6d5e7d90be9 ("clk-divider: Fix READ_ONLY when divider > 1")
> Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
> ---
>   drivers/clk/clk-divider.c | 10 ++++++++++
>   1 file changed, 10 insertions(+)
> 
> diff --git a/drivers/clk/clk-divider.c b/drivers/clk/clk-divider.c
> index b49942b9fe50..a851d3e04c7f 100644
> --- a/drivers/clk/clk-divider.c
> +++ b/drivers/clk/clk-divider.c
> @@ -348,6 +348,7 @@ static long clk_divider_round_rate(struct clk_hw *hw, unsigned long rate,
>   				unsigned long *prate)
>   {
>   	struct clk_divider *divider = to_clk_divider(hw);
> +	struct clk_hw *hw_parent = clk_hw_get_parent(hw);

Very minor suggestion: This could be moved inside the if block since it is only used there.

>   	int bestdiv;
>   
>   	/* if read only, just return current value */
> @@ -356,6 +357,15 @@ static long clk_divider_round_rate(struct clk_hw *hw, unsigned long rate,
>   		bestdiv &= div_mask(divider->width);
>   		bestdiv = _get_div(divider->table, bestdiv, divider->flags,
>   			divider->width);
> +
> +		/* Even a read-only clock can propagate a rate change */
> +		if (clk_hw_get_flags(hw) & CLK_SET_RATE_PARENT) {
> +			if (!hw_parent)
> +				return -EINVAL;
> +
> +			*prate = clk_hw_round_rate(hw_parent, rate * bestdiv);
> +		}
> +
>   		return DIV_ROUND_UP_ULL((u64)*prate, bestdiv);
>   	}
>   
> 

Tested-by: David Lechner <david at lechnology.com>