[PATCH V3 2/2] cpufreq: imx6q: add 696MHz operating point for i.mx6ul

[Viresh Kumar]

On 08-01-18, 10:04, Anson Huang wrote:
> Add 696MHz operating point for i.MX6UL, only for those
> parts with speed grading fuse set to 2b'10 supports
> 696MHz operating point, so, speed grading check is also
> added for i.MX6UL in this patch, the clock tree for each
> operating point are as below:
> 
> 696MHz:
>     pll1                       696000000
>        pll1_bypass             696000000
>           pll1_sys             696000000
>              pll1_sw           696000000
>                 arm            696000000
> 528MHz:
>     pll2                       528000000
>        pll2_bypass             528000000
>           pll2_bus             528000000
>              ca7_secondary_sel 528000000
>                 step           528000000
>                    pll1_sw     528000000
>                       arm      528000000
> 396MHz:
>     pll2_pfd2_396m             396000000
>        ca7_secondary_sel       396000000
>           step                 396000000
>              pll1_sw           396000000
>                 arm            396000000
> 198MHz:
>     pll2_pfd2_396m             396000000
>        ca7_secondary_sel       396000000
>           step                 396000000
>              pll1_sw           396000000
>                 arm            198000000
> 
> Signed-off-by: Anson Huang <Anson.Huang at nxp.com>
> Reviewed-by: Fabio Estevam <fabio.estevam at nxp.com>
> ---
> changes since v2:
> 	add reviewed-by.
>  drivers/cpufreq/imx6q-cpufreq.c | 46 ++++++++++++++++++++++++++++++++++++++++-
>  1 file changed, 45 insertions(+), 1 deletion(-)

Acked-by: Viresh Kumar <viresh.kumar at linaro.org>

-- 
viresh