[PATCH v3 0/6] arm: sunxi: IR support for A83T
maxime.ripard at free-electrons.com
Fri Jan 5 06:59:13 PST 2018
On Fri, Jan 05, 2018 at 12:02:53PM +0000, Sean Young wrote:
> On Tue, Dec 19, 2017 at 09:07:41AM +0100, Philipp Rossak wrote:
> > This patch series adds support for the sunxi A83T ir module and enhances
> > the sunxi-ir driver. Right now the base clock frequency for the ir driver
> > is a hard coded define and is set to 8 MHz.
> > This works for the most common ir receivers. On the Sinovoip Bananapi M3
> > the ir receiver needs, a 3 MHz base clock frequency to work without
> > problems with this driver.
> > This patch series adds support for an optinal property that makes it able
> > to override the default base clock frequency and enables the ir interface
> > on the a83t and the Bananapi M3.
> > changes since v2:
> > * reorder cir pin (alphabetical)
> > * fix typo in documentation
> > changes since v1:
> > * fix typos, reword Documentation
> > * initialize 'b_clk_freq' to 'SUNXI_IR_BASE_CLK' & remove if statement
> > * change dev_info() to dev_dbg()
> > * change naming to cir* in dts/dtsi
> > * Added acked Ackedi-by to related patch
> > * use whole memory block instead of registers needed + fix for h3/h5
> > changes since rfc:
> > * The property is now optinal. If the property is not available in
> > the dtb the driver uses the default base clock frequency.
> > * the driver prints out the the selected base clock frequency.
> > * changed devicetree property from base-clk-frequency to clock-frequency
> > Regards,
> > Philipp
> > Philipp Rossak (6):
> > media: rc: update sunxi-ir driver to get base clock frequency from
> > devicetree
> > media: dt: bindings: Update binding documentation for sunxi IR
> > controller
> > arm: dts: sun8i: a83t: Add the cir pin for the A83T
> > arm: dts: sun8i: a83t: Add support for the cir interface
> > arm: dts: sun8i: a83t: bananapi-m3: Enable IR controller
> > arm: dts: sun8i: h3-h8: ir register size should be the whole memory
> > block
> I can take this series (through rc-core, i.e. linux-media), but I need an
> maintainer Acked-by: for the sun[x8]i dts changes (all four patches).
We'll merge them through our tree. We usually have a rather big number
of patches around, so we'd be better off avoiding conflicts :)
Philipp, can you resubmit the DTs as soon as -rc1 is out?
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 833 bytes
Desc: not available
More information about the linux-arm-kernel