[PATCH 1/2] ARM: dts: imx6ul: add 696MHz operating point

Anson Huang anson.huang at nxp.com
Tue Jan 2 18:09:11 PST 2018


Post this discussion mail to kernel mail list, since last mail is rejected due to incorrect format, sorry for confusion. 

Best Regards!
Anson Huang


> -----Original Message-----
> From: Fabio Estevam [mailto:festevam at gmail.com]
> Sent: 2018-01-02 11:32 PM
> To: Anson Huang <anson.huang at nxp.com>
> Cc: moderated list:ARM/FREESCALE IMX / MXC ARM ARCHITECTURE <linux-
> arm-kernel at lists.infradead.org>; open list:OPEN FIRMWARE AND FLATTENED
> DEVICE TREE BINDINGS <devicetree at vger.kernel.org>; linux-
> pm at vger.kernel.org; linux-kernel <linux-kernel at vger.kernel.org>; Mark
> Rutland <mark.rutland at arm.com>; A.s. Dong <aisheng.dong at nxp.com>; Jacky
> Bai <ping.bai at nxp.com>; viresh kumar <viresh.kumar at linaro.org>;
> rjw at rjwysocki.net; Russell King - ARM Linux <linux at armlinux.org.uk>; Rob
> Herring <robh+dt at kernel.org>; Sascha Hauer <kernel at pengutronix.de>;
> Fabio Estevam <fabio.estevam at nxp.com>; Shawn Guo
> <shawnguo at kernel.org>
> Subject: Re: [PATCH 1/2] ARM: dts: imx6ul: add 696MHz operating point
> 
> On Tue, Jan 2, 2018 at 1:12 PM, Anson Huang <anson.huang at nxp.com> wrote:
> 
> > There is a comment in VDD_ARM, VDD_SOC must NOT lower than VDD_ARM.
> >
> > Output voltage must be set to the following rules:
> > • VDD_ARM_CAP <= VDD_SOC_CAP
> > • VDD_SOC_CAP - VDD_ARM_CAP < 330 mV
> 
> Thanks for the clarifcation.
> 
> Reviewed-by: Fabio Estevam <fabio.estevam at nxp.com>


More information about the linux-arm-kernel mailing list