[PATCH v3 20/34] clk: nxp: change lpc18xx_pll0_round_rate() return logic

[Bryan O'Donoghue]

This patch updates the round_rate() logic here to return zero instead of a
negative number on error.

In conjunction with higher-level changes associated with acting on the
return value of clk_ops->round_rate() it is then possible to have
clk_ops->round_rate() return values from 1 Hz to ULONG_MAX Hz instead of
the current limitation of 1 Hz to LONG_MAX Hz.

Signed-off-by: Bryan O'Donoghue <pure.logic at nexus-software.ie>
Cc: Michael Turquette <mturquette at baylibre.com>
Cc: Stephen Boyd <sboyd at codeaurora.org>
Cc: Joachim Eastwood <manabian at gmail.com>
Cc: linux-clk at vger.kernel.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: linux-kernel at vger.kernel.org
---
 drivers/clk/nxp/clk-lpc18xx-cgu.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/clk/nxp/clk-lpc18xx-cgu.c b/drivers/clk/nxp/clk-lpc18xx-cgu.c
index e08bad9..396d4f7 100644
--- a/drivers/clk/nxp/clk-lpc18xx-cgu.c
+++ b/drivers/clk/nxp/clk-lpc18xx-cgu.c
@@ -381,13 +381,13 @@ static unsigned long lpc18xx_pll0_round_rate(struct clk_hw *hw,
 
 	if (*prate < rate) {
 		pr_warn("%s: pll dividers not supported\n", __func__);
-		return -EINVAL;
+		return 0;
 	}
 
 	m = DIV_ROUND_UP_ULL(*prate, rate * 2);
 	if (m <= 0 && m > LPC18XX_PLL0_MSEL_MAX) {
 		pr_warn("%s: unable to support rate %lu\n", __func__, rate);
-		return -EINVAL;
+		return 0;
 	}
 
 	return 2 * *prate * m;
-- 
2.7.4