[PATCH v2 15/15] ARM: dts: dra7: Add high speed modes capability to MMC1/MMC2 dt node

[Tony Lindgren]

* Sekhar Nori <nsekhar at ti.com> [180213 11:11]:
> On Wednesday 07 February 2018 02:51 PM, Kishon Vijay Abraham I wrote:
> > Hi,
> > 
> > On Wednesday 07 February 2018 02:41 PM, Sekhar Nori wrote:
> >> Kishon,
> >>
> >> On Tuesday 06 February 2018 06:28 PM, Kishon Vijay Abraham I wrote:
> >>> Add UHS/HS200/DDR speed mode capability to MMC1 and MMC2 dt nodes.
> >>>
> >>> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
> >>
> >> Along with this, dont we need to have
> >>
> >> 	/delete-property/ mmc-hs200-1_8v;
> >>
> >> for eMMC on Beagle x15 which does not support HS200?
> >>
> >> Or are you planning to depend on lack of pinctrl entries for HS200 to
> >> take care of that?
> > 
> > right now it relies on lack of pinctrl entries but I think adding delete
> > property is appropriate. Actually I missed porting the patch that adds
> > /delete-property/.
> 
> Actually, thinking more, this should be probably be handled using
> "no-1-8-v" property. Reading the comment above SDHCI_QUIRK2_NO_1_8_V, it
> is specifically meant for the case when system (board) does not support
> 1.8V even when host (controller) does. Which is exactly the case with
> Beagle x15.

OK so that seems to be related to the last patch. I've applied
the first two defconfig patches into omap-for-v4.17/defconfig
and patches up to patch 13/15 into omap-for-v4.17/dt-sdhci.

Kishon, please repost the missing changes or ping me when
the driver dependencies have cleared for further patches to
be applied to enable sdhci.

Regards,

Tony