[PATCH v3 04/10] pinctrl: actions: Add Actions S900 pinctrl driver
Andy Shevchenko
andy.shevchenko at gmail.com
Wed Feb 28 10:36:53 PST 2018
On Wed, Feb 28, 2018 at 8:14 PM, Manivannan Sadhasivam
<manivannan.sadhasivam at linaro.org> wrote:
> Add pinctrl driver for Actions Semi S900 SoC. The driver supports
> pinctrl, pinmux and pinconf functionalities through a range of registers
> common to both gpio driver and pinctrl driver.
>
> Pinmux functionality is available only for the pin groups while the
> pinconf functionality is available for both pin groups and individual
> pins.
> +static int owl_set_mux(struct pinctrl_dev *pctrldev,
> + unsigned int function,
> + unsigned int group)
> +{
> + mfpval = readl(pctrl->base + g->mfpctl_reg);
> + mfpval &= ~mask;
> + mfpval |= val;
> + writel(mfpval, pctrl->base + g->mfpctl_reg);
This is called owl_update_bits().
> +static int owl_pin_config_set(struct pinctrl_dev *pctrldev,
> + unsigned int pin,
> + unsigned long *configs,
> + unsigned int num_configs)
> +{
> + int ret = 0;
Redundant assignment?
> + mask = (1 << width) - 1;
> + mask = mask << bit;
> + tmp = readl(pctrl->base + reg);
> + tmp &= ~mask;
> + tmp |= arg << bit;
> + writel(tmp, pctrl->base + reg);
This is called owl_update_bits().
> +}
> +static int owl_group_pinconf_val2arg(const struct owl_pingroup *g,
> + unsigned int param,
> + u32 *arg)
> +{
> + case PIN_CONFIG_SLEW_RATE:
> + if (*arg)
> + *arg = 1;
> + else
> + *arg = 0;
Doesn't slew rate allow a non-binary value?
> + return 0;
> +}
> +
> +static int owl_group_config_get(struct pinctrl_dev *pctrldev,
> + unsigned int group,
> + unsigned long *config)
> +{
> + int ret = 0;
Redundant assignment.
> +}
> +static int owl_group_config_set(struct pinctrl_dev *pctrldev,
> + unsigned int group,
> + unsigned long *configs,
> + unsigned int num_configs)
> +{
> + int ret = 0;
Redundant assignment, see below.
> + mask = (1 << width) - 1;
> + mask = mask << bit;
> + tmp = readl(pctrl->base + reg);
> + tmp &= ~mask;
> + tmp |= arg << bit;
> + writel(tmp, pctrl->base + reg);
This is called owl_update_bits().
> + return ret;
return 0; ?
> +}
> +int owl_pinctrl_probe(struct platform_device *pdev,
> + struct owl_pinctrl_soc_data *soc_data)
> +{
> + clk_prepare_enable(pctrl->clk);
This can fail.
> +}
> +static const struct of_device_id s900_pinctrl_of_match[] = {
> + { .compatible = "actions,s900-pinctrl", },
> + { },
No comma needed.
> +};
--
With Best Regards,
Andy Shevchenko
More information about the linux-arm-kernel
mailing list