[PATCH 4/6] ARM: dts: stm32: add MFX support on I2C1 on stm32746g-eval

[Linus Walleij]

On Thu, Feb 8, 2018 at 3:27 PM, Amelie Delaunay <amelie.delaunay at st.com> wrote:

> MFX is used as gpio expander on stm32746g-eval.
>
> Signed-off-by: Amelie Delaunay <amelie.delaunay at st.com>

(...)
> +       mfx: mfx at 42 {
> +               compatible = "st,mfx";
> +               reg = <0x42>;
> +               interrupts = <8 1>;
> +               interrupt-parent = <&gpioi>;
> +               interrupt-controller;
> +               #interrupt-cells = <1>;
> +
> +               mfxgpio: mfx_gpio {
> +                       compatible = "st,mfx-gpio";
> +                       interrupts = <0>;
> +                       interrupt-parent = <&mfx>;
> +                       gpio-controller;
> +                       #gpio-cells = <2>;

So I think this node should contain some pin config states
that can  be referenced by the drivers to set up push/pull
etc. Probably it can use just standard pin config properties
like sx150x.

Yours,
Linus Walleij