[PATCH] cpufreq: imx6q: support frequencies >528MHz for i.MX6UL/ULL

[Rafael J. Wysocki]

On Friday, January 19, 2018 12:58:36 AM CET Stefan Agner wrote:
> Depending on SKU i.MX6UL/i.MX6ULL support frequencies up to 900MHz.
> Use PLL1 sys clock for all operating points higher than 528MHz.
> 
> Note: For higher operating points VDD_SOC_IN needs to be 125mV
> higher than the ARM set-point (see datasheet). Specifically, the
> i.MX6UL/ULL EVK boards have an external DC regulator which needs
> adjustment. The regulator adjustment is not covered with this
> change.
> 
> Signed-off-by: Stefan Agner <stefan at agner.ch>

This makes sense to me, but I need someone with the requisite platform
knowledge to review it.

> ---
>  drivers/cpufreq/imx6q-cpufreq.c | 14 ++++++++------
>  1 file changed, 8 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/cpufreq/imx6q-cpufreq.c b/drivers/cpufreq/imx6q-cpufreq.c
> index 628fe899cb48..840f6386c780 100644
> --- a/drivers/cpufreq/imx6q-cpufreq.c
> +++ b/drivers/cpufreq/imx6q-cpufreq.c
> @@ -114,12 +114,14 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index)
>  		 */
>  		clk_set_rate(arm_clk, (old_freq >> 1) * 1000);
>  		clk_set_parent(pll1_sw_clk, pll1_sys_clk);
> -		if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> -			clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> -		else
> -			clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
> -		clk_set_parent(step_clk, secondary_sel_clk);
> -		clk_set_parent(pll1_sw_clk, step_clk);
> +		if (freq_hz <= clk_get_rate(pll2_bus_clk)) {
> +			if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> +				clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> +			else
> +				clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
> +			clk_set_parent(step_clk, secondary_sel_clk);
> +			clk_set_parent(pll1_sw_clk, step_clk);
> +		}
>  	} else {
>  		clk_set_parent(step_clk, pll2_pfd2_396m_clk);
>  		clk_set_parent(pll1_sw_clk, step_clk);
>