[PATCH v2 14/16] arm64: dts: mt7622: add thermal and related nodes

[sean.wang at mediatek.com]

From: Sean Wang <sean.wang at mediatek.com>

add nodes for the thermal controller and associated thermal zone using
CPU as the cooling device for each trip point. In addition, add a fixup
for thermal_calibration on nvmem should be 12 bytes as the minimal
requirement.

Signed-off-by: Sean Wang <sean.wang at mediatek.com>
---
 arch/arm64/boot/dts/mediatek/mt7622.dtsi | 72 +++++++++++++++++++++++++++++++-
 1 file changed, 71 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/mediatek/mt7622.dtsi b/arch/arm64/boot/dts/mediatek/mt7622.dtsi
index e6dd4f6..6cf67dd 100644
--- a/arch/arm64/boot/dts/mediatek/mt7622.dtsi
+++ b/arch/arm64/boot/dts/mediatek/mt7622.dtsi
@@ -12,6 +12,7 @@
 #include <dt-bindings/phy/phy.h>
 #include <dt-bindings/power/mt7622-power.h>
 #include <dt-bindings/reset/mt7622-reset.h>
+#include <dt-bindings/thermal/thermal.h>
 
 / {
 	compatible = "mediatek,mt7622";
@@ -75,6 +76,7 @@
 				 <&apmixedsys CLK_APMIXED_MAIN_CORE_EN>;
 			clock-names = "cpu", "intermediate";
 			operating-points-v2 = <&cpu_opp_table>;
+			#cooling-cells = <2>;
 			enable-method = "psci";
 			clock-frequency = <1300000000>;
 		};
@@ -119,6 +121,58 @@
 		};
 	};
 
+	thermal-zones {
+		cpu_thermal: cpu-thermal {
+			polling-delay-passive = <1000>;
+			polling-delay = <1000>;
+
+			thermal-sensors = <&thermal 0>;
+
+			trips {
+				cpu_passive: cpu-passive {
+					temperature = <47000>;
+					hysteresis = <2000>;
+					type = "passive";
+				};
+
+				cpu_active: cpu-active {
+					temperature = <67000>;
+					hysteresis = <2000>;
+					type = "active";
+				};
+
+				cpu_hot: cpu-hot {
+					temperature = <87000>;
+					hysteresis = <2000>;
+					type = "hot";
+				};
+
+				cpu-crit {
+					temperature = <107000>;
+					hysteresis = <2000>;
+					type = "critical";
+				};
+			};
+
+			cooling-maps {
+				map0 {
+					trip = <&cpu_passive>;
+					cooling-device = <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+				};
+
+				map1 {
+					trip = <&cpu_active>;
+					cooling-device = <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+				};
+
+				map2 {
+					trip = <&cpu_hot>;
+					cooling-device = <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+				};
+			};
+		};
+	};
+
 	timer {
 		compatible = "arm,armv8-timer";
 		interrupt-parent = <&gic>;
@@ -201,7 +255,7 @@
 		#size-cells = <1>;
 
 		thermal_calibration: calib at 198 {
-			reg = <0x198 0x8>;
+			reg = <0x198 0xc>;
 		};
 	};
 
@@ -384,6 +438,22 @@
 		status = "disabled";
 	};
 
+	thermal: thermal at 1100b000 {
+		#thermal-sensor-cells = <1>;
+		compatible = "mediatek,mt7622-thermal";
+		reg = <0 0x1100b000 0 0x1000>;
+		interrupts = <0 78 IRQ_TYPE_LEVEL_LOW>;
+		clocks = <&pericfg CLK_PERI_THERM_PD>,
+			 <&pericfg CLK_PERI_AUXADC_PD>;
+		clock-names = "therm", "auxadc";
+		resets = <&pericfg MT7622_PERI_THERM_SW_RST>;
+		reset-names = "therm";
+		mediatek,auxadc = <&auxadc>;
+		mediatek,apmixedsys = <&apmixedsys>;
+		nvmem-cells = <&thermal_calibration>;
+		nvmem-cell-names = "calibration-data";
+	};
+
 	btif: serial at 1100c000 {
 		compatible = "mediatek,mt7622-btif",
 			     "mediatek,mtk-btif";
-- 
2.7.4