[PATCH 2/7] ARM: dts: sun8i: h3: Split out common board design for ALL-H3-CC

[Chen-Yu Tsai]

On Wed, Apr 25, 2018 at 3:37 AM, Maxime Ripard
<maxime.ripard at bootlin.com> wrote:
> On Tue, Apr 24, 2018 at 08:17:11PM +0800, Chen-Yu Tsai wrote:
>> On Tue, Apr 24, 2018 at 8:13 PM, Maxime Ripard
>> <maxime.ripard at bootlin.com> wrote:
>> > On Tue, Apr 24, 2018 at 07:34:19PM +0800, Chen-Yu Tsai wrote:
>> >> The Libre Computer Project ALL-H3-CC has three models, all using the
>> >> same board design, but with different pin compatible SoCs and amount of
>> >> DRAM.
>> >>
>> >> Currently only the H3 1GB DRAM variant is supported. To support the two
>> >> other variants, first split the original device tree into a common board
>> >> design part and an SoC specific part.
>> >>
>> >> The SoC part only defines which SoC is used and model name, and includes
>> >> the SoC specific dtsi file and the common design dtsi file.
>> >>
>> >> Also fix up the SPDX identifier line to use the correct comment style,
>> >> and place it on the first line.
>> >>
>> >> Signed-off-by: Chen-Yu Tsai <wens at csie.org>
>> >> ---
>> >>  .../boot/dts/sun8i-h3-libretech-all-h3-cc.dts | 213 +-----------------
>> >>  ....dts => sunxi-hx-libretech-all-h3-cc.dtsi} |  11 +-
>> >
>> > I think I prefer the name of Neil's DTSI better, and since pretty much
>> > the same patches (a couple of hours) before, we'll merge them (while
>> > merging the rest of your patches, obviously).
>> >
>> > Does that work for you?
>>
>> I would like for the regulator voltage fix to be merged before the split.
>> This will make it trivial to back port, instead of having to reverse the
>> split, and maybe failing.
>
> Yes, I was just talking about replacing your two redundant patches,
> but keeping the order you have.

That works for me. Might require a little fixing up.
Let me know if you need help with that.

ChenYu