[RESEND PATCH v6 01/27] drm/bridge: analogix_dp: Move enable video into config_video()

[Enric Balletbo i Serra]

From: Lin Huang <hl at rock-chips.com>

We need to enable video before analogix_dp_is_video_stream_on(), so
we can get the right video stream status.

We needed to increase the delay in the timeout loop because there is
random "Timeout of video streamclk ok" message happen when debug edp
panel, this time do not define in the spec.

Cc: 征增 王 <wzz at rock-chips.com>
Cc: Stéphane Marchesin <marcheu at chromium.org>
Signed-off-by: Lin Huang <hl at rock-chips.com>
Signed-off-by: Sean Paul <seanpaul at chromium.org>
Signed-off-by: Thierry Escande <thierry.escande at collabora.com>
Reviewed-by: Andrzej Hajda <a.hajda at samsung.com>
Signed-off-by: Enric Balletbo i Serra <enric.balletbo at collabora.com>
Tested-by: Marek Szyprowski <m.szyprowski at samsung.com>
---

 drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 11 +++++------
 1 file changed, 5 insertions(+), 6 deletions(-)

diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
index 5c52307146c7..05a0ca4af057 100644
--- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
+++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
@@ -819,11 +819,10 @@ static int analogix_dp_config_video(struct analogix_dp_device *dp)
 		if (analogix_dp_is_slave_video_stream_clock_on(dp) == 0)
 			break;
 		if (timeout_loop > DP_TIMEOUT_LOOP_COUNT) {
-			dev_err(dp->dev, "Timeout of video streamclk ok\n");
+			dev_err(dp->dev, "Timeout of slave video streamclk ok\n");
 			return -ETIMEDOUT;
 		}
-
-		usleep_range(1, 2);
+		usleep_range(1000, 1001);
 	}
 
 	/* Set to use the register calculated M/N video */
@@ -838,6 +837,9 @@ static int analogix_dp_config_video(struct analogix_dp_device *dp)
 	/* Configure video slave mode */
 	analogix_dp_enable_video_master(dp, 0);
 
+	/* Enable video */
+	analogix_dp_start_video(dp);
+
 	timeout_loop = 0;
 
 	for (;;) {
@@ -948,9 +950,6 @@ static void analogix_dp_commit(struct analogix_dp_device *dp)
 			DRM_ERROR("failed to enable the panel\n");
 	}
 
-	/* Enable video */
-	analogix_dp_start_video(dp);
-
 	dp->psr_enable = analogix_dp_detect_sink_psr(dp);
 	if (dp->psr_enable)
 		analogix_dp_enable_sink_psr(dp);
-- 
2.17.0