[PATCH 1/4] serial: uartps: Remove console_initcall from the driver

[Michal Simek]

register_console() is called from
uart_add_one_port()->uart_configure_port()
that's why register_console() is called twice.

This patch remove console_initcall to call register_console() only from
one location.

Also based on my tests cdns_uart_console_setup() is not called
from the first register_console() call.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
Reviewed-by: Alan Cox <alan at linux.intel.com>
---

I am not quite sure about this because console_initcall is called
early but I can see any difference in usage.
pl011 is not calling this but others are doing it.
---
 drivers/tty/serial/xilinx_uartps.c | 14 --------------
 1 file changed, 14 deletions(-)

diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c
index bd72dd843338..932210331484 100644
--- a/drivers/tty/serial/xilinx_uartps.c
+++ b/drivers/tty/serial/xilinx_uartps.c
@@ -1293,20 +1293,6 @@ static struct console cdns_uart_console = {
 	.index	= -1, /* Specified on the cmdline (e.g. console=ttyPS ) */
 	.data	= &cdns_uart_uart_driver,
 };
-
-/**
- * cdns_uart_console_init - Initialization call
- *
- * Return: 0 on success, negative errno otherwise
- */
-static int __init cdns_uart_console_init(void)
-{
-	register_console(&cdns_uart_console);
-	return 0;
-}
-
-console_initcall(cdns_uart_console_init);
-
 #endif /* CONFIG_SERIAL_XILINX_PS_UART_CONSOLE */
 
 static struct uart_driver cdns_uart_uart_driver = {
-- 
2.17.0