[PATCH v6 1/3] regulator: axp20x: add drivevbus support for axp803

[Jagan Teki]

Like axp221, axp223, axp813 the axp803 is also supporting external
regulator to drive the  OTG VBus through N_VBUSEN PMIC pin.

Add support for it.

Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
Reviewed-by: Rob Herring <robh at kernel.org>
Reviewed-by: Chen-Yu Tsai <wens at csie.org>
---
Changes for v6:
- Rebase on master 
Changes for v5:
- Collect Chen-Yu reviewed-by tag
Changes for v4:
- rebase on master
Changes for v3:
- Update drivevbus in table of regulators

 Documentation/devicetree/bindings/mfd/axp20x.txt | 3 ++-
 drivers/regulator/axp20x-regulator.c             | 2 ++
 2 files changed, 4 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt
index 9455503b0299..d1762f3b30af 100644
--- a/Documentation/devicetree/bindings/mfd/axp20x.txt
+++ b/Documentation/devicetree/bindings/mfd/axp20x.txt
@@ -43,7 +43,7 @@ Optional properties:
 			  regulator to drive the OTG VBus, rather then
 			  as an input pin which signals whether the
 			  board is driving OTG VBus or not.
-			  (axp221 / axp223 / axp813 only)
+			  (axp221 / axp223 / axp803/ axp813 only)
 
 - x-powers,master-mode: Boolean (axp806 only). Set this when the PMIC is
 			wired for master mode. The default is slave mode.
@@ -132,6 +132,7 @@ FLDO2		: LDO		: fldoin-supply		: shared supply
 LDO_IO0		: LDO		: ips-supply		: GPIO 0
 LDO_IO1		: LDO		: ips-supply		: GPIO 1
 RTC_LDO		: LDO		: ips-supply		: always on
+DRIVEVBUS	: Enable output	: drivevbus-supply	: external regulator
 
 AXP806 regulators, type, and corresponding input supply names:
 
diff --git a/drivers/regulator/axp20x-regulator.c b/drivers/regulator/axp20x-regulator.c
index 181622b2813d..91b8ff8bac15 100644
--- a/drivers/regulator/axp20x-regulator.c
+++ b/drivers/regulator/axp20x-regulator.c
@@ -721,6 +721,8 @@ static int axp20x_regulator_probe(struct platform_device *pdev)
 	case AXP803_ID:
 		regulators = axp803_regulators;
 		nregulators = AXP803_REG_ID_MAX;
+		drivevbus = of_property_read_bool(pdev->dev.parent->of_node,
+						  "x-powers,drive-vbus-en");
 		break;
 	case AXP806_ID:
 		regulators = axp806_regulators;
-- 
2.14.3