[PATCH 16/27] dt-bindings: cp110: prepare the syscon file to list other syscons nodes

[Miquel Raynal]

There are multiple system controllers in CP110. Because all syscon nodes
use the same compatible, it is pertinent to use this same file to list
IPs inside it. Thus, change the header to be more generic, and align
with AP806 file.

Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
---
 .../bindings/arm/marvell/cp110-system-controller.txt       | 14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
index 29cdbae6c5ac..56e7fb1153e7 100644
--- a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
+++ b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
@@ -1,15 +1,15 @@
-Marvell Armada CP110 System Controller 0
-========================================
+Marvell Armada CP110 System Controller
+======================================
 
 The CP110 is one of the two core HW blocks of the Marvell Armada 7K/8K
-SoCs. It contains two sets of system control registers, System
-Controller 0 and System Controller 1. This Device Tree binding allows
-to describe the first system controller, which provides registers to
-configure various aspects of the SoC.
+SoCs. It contains system controllers, which provide several registers
+giving access to numerous features: clocks, pin-muxing and many other
+SoC configuration items. This DT binding allows to describe these
+system controllers.
 
 For the top level node:
  - compatible: must be: "syscon", "simple-mfd";
- - reg: register area of the CP110 system controller 0
+ - reg: register area of the CP110 system controller
 
 Clocks:
 -------
-- 
2.14.1