LS1043A : "synchronous abort" at boot due to PCI config read

[Gilles Buloz]

Dear developers,

I currently have two functional workarounds for this issue but would like to know which one you would recommend, if any :-)
I'm using a LS1043A CPU (NXP QorIQ Layerscape) and get a "synchronous external abort" when booting because of a PCI config read 
during PCI scan.

I'm using a custom hardware (based on LS1043ARDB) having a PEX8112 PCIe-to-PCI bridge connected to the LS1043A to have a PCI slot 
for legacy devices. This bridge only supports PCI-Compatible config accesses (offset 0x00-0xFF).
On this PCI slot I connect a PCI module made of a PCI-to-PCIe bridge plus PCIe devices behind.
The problem occurs when the kernel probes the PCIe devices : as they are PCIe devices, the kernel does a PCI config read access at 
offset 0x100 to check if "PCIe extended capability registers" are accessible (see drivers/pci/probe.c, function 
pci_cfg_space_size_ext()). Unfortunately the PEX8112 PCIe-to-PCI bridge that is in the path reports an error to the CPU for this 
access, and it seems there's no way to disable that on this bridge.

The first workaround I found was to patch drivers/pci/host/pci-layerscape.c to have PCIE_ABSERR_SETTING set to 0x9400 instead of 
0x9401 (for PCIE_ABSERR register) to disable error reporting. This only impacts an NXP part of the Linux kernel code, but I'm not 
sure this is a good idea (however it seems to be like that on Intel platforms where even MEM accesses to a no-device address return 
FF without any error).

I've also tried another workaround that works : patch drivers/pci/probe.c to use bus_flags to remember if a bus is behind a bridge 
without extended address capability, to avoid PCi config read accesses at offset 0x100 in
pci_cfg_space_size() / pci_cfg_space_size_ext(). But this patch impacts the generic PCI probe method of Linux.

Any Idea to properly handle that issue ?

Best regards