[PATCH 15/17] media: st_rc: Don't stay on an IRQ handler forever

Patrice CHOTARD patrice.chotard at st.com
Fri Apr 13 01:03:16 PDT 2018


Hi Mauro

On 04/12/2018 05:24 PM, Mauro Carvalho Chehab wrote:
> As warned by smatch:
> 	drivers/media/rc/st_rc.c:110 st_rc_rx_interrupt() warn: this loop depends on readl() succeeding
> 
> If something goes wrong at readl(), the logic will stay there
> inside an IRQ code forever. This is not the nicest thing to
> do :-)
> 
> So, add a timeout there, preventing staying inside the IRQ
> for more than 10ms.
> 
> Signed-off-by: Mauro Carvalho Chehab <mchehab at s-opensource.com>
> ---
>   drivers/media/rc/st_rc.c | 16 ++++++++++------
>   1 file changed, 10 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/media/rc/st_rc.c b/drivers/media/rc/st_rc.c
> index d2efd7b2c3bc..c855b177103c 100644
> --- a/drivers/media/rc/st_rc.c
> +++ b/drivers/media/rc/st_rc.c
> @@ -96,19 +96,24 @@ static void st_rc_send_lirc_timeout(struct rc_dev *rdev)
>   
>   static irqreturn_t st_rc_rx_interrupt(int irq, void *data)
>   {
> +	unsigned long timeout;
>   	unsigned int symbol, mark = 0;
>   	struct st_rc_device *dev = data;
>   	int last_symbol = 0;
> -	u32 status;
> +	u32 status, int_status;
>   	DEFINE_IR_RAW_EVENT(ev);
>   
>   	if (dev->irq_wake)
>   		pm_wakeup_event(dev->dev, 0);
>   
> -	status  = readl(dev->rx_base + IRB_RX_STATUS);
> +	/* FIXME: is 10ms good enough ? */
> +	timeout = jiffies +  msecs_to_jiffies(10);
> +	do {
> +		status  = readl(dev->rx_base + IRB_RX_STATUS);
> +		if (!(status & (IRB_FIFO_NOT_EMPTY | IRB_OVERFLOW)))
> +			break;
>   
> -	while (status & (IRB_FIFO_NOT_EMPTY | IRB_OVERFLOW)) {
> -		u32 int_status = readl(dev->rx_base + IRB_RX_INT_STATUS);
> +		int_status = readl(dev->rx_base + IRB_RX_INT_STATUS);
>   		if (unlikely(int_status & IRB_RX_OVERRUN_INT)) {
>   			/* discard the entire collection in case of errors!  */
>   			ir_raw_event_reset(dev->rdev);
> @@ -148,8 +153,7 @@ static irqreturn_t st_rc_rx_interrupt(int irq, void *data)
>   
>   		}
>   		last_symbol = 0;
> -		status  = readl(dev->rx_base + IRB_RX_STATUS);
> -	}
> +	} while (time_is_after_jiffies(timeout));
>   
>   	writel(IRB_RX_INTS, dev->rx_base + IRB_RX_INT_CLEAR);
>   
> 

Acked-by: Patrice Chotard <patrice.chotard at st.com>

Thanks

Patrice


More information about the linux-arm-kernel mailing list