[PATCH v4 6/8] ARM: dts: Renesas RZ/N1 SoC base device tree file

[Michel Pollet]

This adds the Renesas RZ/N1D (Part #R9A06G032) SoC bare
bone support.

This currently only handles generic parts (gic, architected timer)
and a UART.
For simplicity sake, this also relies on the bootloader to set the
pinctrl and clocks.

Signed-off-by: Michel Pollet <michel.pollet at bp.renesas.com>
---
 arch/arm/boot/dts/r9a06g032.dtsi | 94 ++++++++++++++++++++++++++++++++++++++++
 1 file changed, 94 insertions(+)
 create mode 100644 arch/arm/boot/dts/r9a06g032.dtsi

diff --git a/arch/arm/boot/dts/r9a06g032.dtsi b/arch/arm/boot/dts/r9a06g032.dtsi
new file mode 100644
index 0000000..7d84b38
--- /dev/null
+++ b/arch/arm/boot/dts/r9a06g032.dtsi
@@ -0,0 +1,94 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Base Device Tree Source for the Renesas RZ/N1D (R9A06G032)
+ *
+ * Copyright (C) 2018 Renesas Electronics Europe Limited
+ *
+ */
+
+#include <dt-bindings/interrupt-controller/arm-gic.h>
+
+/ {
+	compatible = "renesas,r9a06g032", "renesas,rzn1";
+	#address-cells = <1>;
+	#size-cells = <1>;
+
+	clkuarts: clkuarts {
+		#clock-cells = <0>;
+		compatible = "fixed-clock";
+		clock-frequency = <47619047>;
+	};
+
+	cpus {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		cpu at 0 {
+			device_type = "cpu";
+			compatible = "arm,cortex-a7";
+			reg = <0>;
+		};
+
+		cpu at 1 {
+			device_type = "cpu";
+			compatible = "arm,cortex-a7";
+			reg = <1>;
+		};
+	};
+
+	soc {
+		compatible = "simple-bus";
+		#address-cells = <1>;
+		#size-cells = <1>;
+		interrupt-parent = <&gic>;
+		ranges;
+
+		sysctrl: sysctrl at 4000c000 {
+			compatible = "renesas,r9a06g032-sysctrl",
+					"renesas,rzn1-sysctrl",
+					"syscon", "simple-mfd";
+			reg = <0x4000c000 0x1000>;
+
+			reboot {
+				compatible = "renesas,r9a06g032-reboot",
+						"renesas,rzn1-reboot";
+			};
+		};
+
+		uart0: serial at 40060000 {
+			compatible = "snps,dw-apb-uart";
+			reg = <0x40060000 0x400>;
+			interrupts = <GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>;
+			reg-shift = <2>;
+			reg-io-width = <4>;
+			clocks = <&clkuarts>;
+			clock-names = "baudclk";
+			status = "disabled";
+		};
+
+		gic: gic at 44101000 {
+			compatible = "arm,cortex-a7-gic", "arm,gic-400";
+			interrupt-controller;
+			#interrupt-cells = <3>;
+			reg = <0x44101000 0x1000>, /* Distributer */
+			      <0x44102000 0x2000>, /* CPU interface */
+			      <0x44104000 0x2000>, /* Virt interface control */
+			      <0x44106000 0x2000>; /* Virt CPU interface */
+			interrupts =
+				<GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_HIGH)>;
+		};
+	};
+
+	timer {
+		compatible = "arm,cortex-a7-timer",
+			     "arm,armv7-timer";
+		interrupt-parent = <&gic>;
+		arm,cpu-registers-not-fw-configured;
+		always-on;
+		interrupts =
+			<GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+			<GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+			<GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+			<GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>;
+	};
+};
-- 
2.7.4