[PATCH v2 1/3] ARM: dts: sun8i: Add basic dtsi file for Allwinner R40

[Icenowy Zheng]

于 2017年9月28日 GMT+08:00 下午11:11:03, Maxime Ripard <maxime.ripard at free-electrons.com> 写到:
>Hi,
>
>On Thu, Sep 28, 2017 at 09:25:41AM +0000, Icenowy Zheng wrote:
>> +		/*
>> +		 * The max-frequency properties in all MMC controller nodes
>> +		 * are conservative values proven to work on Banana Pi M2
>> +		 * Ultra (the first community available R40 board).
>> +		 * As the board doesn't wire MMC3 out, the property is not
>> +		 * set in MMC3.
>> +		 * TODO: measure the accurate max frequency of the controllers.
>> +		 */
>> +		mmc0: mmc at 1c0f000 {
>> +			compatible = "allwinner,sun8i-r40-mmc",
>> +				     "allwinner,sun50i-a64-mmc";
>> +			reg = <0x01c0f000 0x1000>;
>> +			clocks = <&ccu CLK_BUS_MMC0>, <&ccu CLK_MMC0>;
>> +			clock-names = "ahb", "mmc";
>> +			resets = <&ccu RST_BUS_MMC0>;
>> +			reset-names = "ahb";
>> +			pinctrl-0 = <&mmc0_pins>;
>> +			pinctrl-names = "default";
>> +			interrupts = <GIC_SPI 32 IRQ_TYPE_LEVEL_HIGH>;
>> +			max-frequency = <25000000>;
>> +			status = "disabled";
>> +			#address-cells = <1>;
>> +			#size-cells = <0>;
>> +		};
>
>Sorry if it wasn't really clear, but my point was more than you should
>just drop the max-frequency property

Then set it in the boards' DTS?

>
>Maxime