[PATCH v3 5/5] mtd: spi-nor: cadence-quadspi: Add runtime PM support

[matthew.gerlach at linux.intel.com]

Hi Vignesh,

I tried this patch on an Arria10 SOCFPGA devkit against the 4.1.33-ltsi 
kernel, and it did not go well.  Commands to the flash chip timedout 
resulting in the probe function failing.  I ran into other problems, not 
related to cadence-quadspi, that prevented me from testing against 4.9 and 
4.12 kernels, but I suspect similar behavior.

Matthew Gerlach

On Wed, 27 Sep 2017, Vignesh R wrote:

> Hi Matthew,
>
> On Tuesday 26 September 2017 05:19 AM, Marek Vasut wrote:
> [...]
>>>>> Ok thanks! Do you know if pm_runtime_get_sync() can enable clocks for
>>>>> QSPI on SoCFPGA or if clk_prepare_enable() is needed? Just trying to see
>>>>> if its possible to get rid of clk_*() calls in favor of pm_*() calls.
>>>>
>>>> Not of the top of my head, sorry. +CC Matthew, he should know.
>>>
>>> I am not an expert at the clock framework nor the power management, but I
>>> did ask around a bit.  No one I asked was planning to change the clk_*()
>>> calls to pm_*() call, but the feedback was that it would be a good idea.
>>
>> The question is, if we do the replacement, will it break on socfpga ?
>> A quick test might be useful.
>>
>
> yes, a quick qspi test with clk_prepare_enable() replaced by pm_*() calls
> like below patch would be helpful:
>
>
> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
> index 53c7d8e0327a..7ad3e176cc88 100644
> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
> @@ -34,6 +34,7 @@
> #include <linux/sched.h>
> #include <linux/spi/spi.h>
> #include <linux/timer.h>
> +#include <linux/pm_runtime.h>
>
> #define CQSPI_NAME                     "cadence-qspi"
> #define CQSPI_MAX_CHIPSELECT           16
> @@ -1206,11 +1207,8 @@ static int cqspi_probe(struct platform_device *pdev)
>                return -ENXIO;
>        }
>
> -       ret = clk_prepare_enable(cqspi->clk);
> -       if (ret) {
> -               dev_err(dev, "Cannot enable QSPI clock.\n");
> -               return ret;
> -       }
> +       pm_runtime_enable(dev);
> +       pm_runtime_get_sync(dev);
>
>        cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
>
>
>
>
>
> -- 
> Regards
> Vignesh
>