[PATCH v6 06/11] ARM: dts: sunxi: h3/h5: represent the mdio switch used by sun8i-h3-emac

[Corentin Labbe]

Since dwmac-sun8i could use either an integrated PHY or an external PHY
(which could be at same MDIO address), we need to represent this selection
by a MDIO switch.

Signed-off-by: Corentin Labbe <clabbe.montjoie at gmail.com>
---
 arch/arm/boot/dts/sunxi-h3-h5.dtsi | 31 +++++++++++++++++++++++++------
 1 file changed, 25 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/sunxi-h3-h5.dtsi b/arch/arm/boot/dts/sunxi-h3-h5.dtsi
index 3b7d953429a6..a8e9b8f378ba 100644
--- a/arch/arm/boot/dts/sunxi-h3-h5.dtsi
+++ b/arch/arm/boot/dts/sunxi-h3-h5.dtsi
@@ -422,14 +422,33 @@
 			#size-cells = <0>;
 			status = "disabled";
 
-			mdio: mdio {
+			mdio0: mdio {
 				#address-cells = <1>;
 				#size-cells = <0>;
-				int_mii_phy: ethernet-phy at 1 {
-					compatible = "ethernet-phy-ieee802.3-c22";
-					reg = <1>;
-					clocks = <&ccu CLK_BUS_EPHY>;
-					resets = <&ccu RST_BUS_EPHY>;
+				compatible = "snps,dwmac-mdio";
+
+				mdio-mux {
+					compatible = "mdio-mux";
+					#address-cells = <1>;
+					#size-cells = <0>;
+					/* Only one MDIO is usable at the time */
+					internal_mdio: mdio at 1 {
+						reg = <1>;
+						#address-cells = <1>;
+						#size-cells = <0>;
+						int_mii_phy: ethernet-phy at 1 {
+							compatible = "ethernet-phy-ieee802.3-c22";
+							reg = <1>;
+							clocks = <&ccu CLK_BUS_EPHY>;
+							resets = <&ccu RST_BUS_EPHY>;
+							phy-is-integrated;
+						};
+					};
+					mdio: mdio at 2 {
+						reg = <2>;
+						#address-cells = <1>;
+						#size-cells = <0>;
+					};
 				};
 			};
 		};
-- 
2.13.5