[PATCH v3 10/10] arm64: allwinner: a64: add dma controller references to spi nodes

[Stefan Brüns]

The spi controller nodes omit the dma controller/channel references, add
it.

This does not yet enable DMA for SPI transfers, as the spi-sun6i driver
lacks support for DMA, but always uses PIO to the FIFO.

Signed-off-by: Stefan Brüns <stefan.bruens at rwth-aachen.de>
---

Changes in v3: None
Changes in v2: None

 arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
index cbffefce0e71..a6a5a40d76d0 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
@@ -476,6 +476,8 @@
 			interrupts = <GIC_SPI 65 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_SPI0>, <&ccu CLK_SPI0>;
 			clock-names = "ahb", "mod";
+			dmas = <&dma 23>, <&dma 23>;
+			dma-names = "rx", "tx";
 			pinctrl-names = "default";
 			pinctrl-0 = <&spi0_pins>;
 			resets = <&ccu RST_BUS_SPI0>;
@@ -491,6 +493,8 @@
 			interrupts = <GIC_SPI 66 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_SPI1>, <&ccu CLK_SPI1>;
 			clock-names = "ahb", "mod";
+			dmas = <&dma 24>, <&dma 24>;
+			dma-names = "rx", "tx";
 			pinctrl-names = "default";
 			pinctrl-0 = <&spi1_pins>;
 			resets = <&ccu RST_BUS_SPI1>;
-- 
2.14.1