[PATCH 0/4] arm64: dts: renesas: Add Support for R-Car D3 and Draak

[Simon Horman]

On Thu, Jul 27, 2017 at 05:16:23PM +0200, Simon Horman wrote:
> On Thu, Jul 20, 2017 at 02:54:33PM +0200, Geert Uytterhoeven wrote:
> > 	Hi Simon, Magnus,
> > 
> > This patch series adds minimal support for the R-Car D3 SoC and the
> > Draak development board, allowing to boot from a ramdisk using a serial
> > console.
> > 
> >   - The first two patches add DT sources for R-Car D3 and Draak.
> >     Due to the use of hardcoded constants, they have no further (build)
> >     dependencies (obviously there is a runtime dependency).
> >   - The last two patches replace the hardcoded constants by symbols from
> >     DT binding headers, and thus depend on those headers.  Hence it
> >     should be postponed to v4.15.
> > 
> > For proper operation, this depends on the 3 series I have just sent:
> >   - [PATCH 0/3] arm64: renesas: Base R-Car D3 support,
> 
> I have applied the above patchset for v4.14.
> 
> >   - [PATCH 0/4] soc: renesas: Add R-Car D3 support,
> 
> And this one too.
> 
> >   - [PATCH 0/4] clk: renesas: Add R-Car D3 support.
> 
> And this one seems to have been acked, so I assume you will
> apply it once you are back from holidays.
> 
> So I have applied the first two patches for v4.14.
> Please repost the remaining two after v4.13-rc6 at which time I should
> be able to queue them up for v4.15.

I have now done so.