[PATCH] thermal: brcmstb: disable trip points properly when needed

[Markus Mayer]

From: Markus Mayer <mmayer at broadcom.com>

The code checking for low and high temperature points was still based
on an earlier implementation of the driver. It wasn't working properly
with the data types currently being used.

We fix this by disabling the high trip point if our high temperature is
INT_MAX and disabling the low trip point if our low temperature is -INT_MAX
(or lower).

Signed-off-by: Markus Mayer <mmayer at broadcom.com>
---

Here is my patch for the issue described. Please let me know if I should be
squashing this into the driver patch and re-submit the entire series.

 drivers/thermal/broadcom/brcmstb_thermal.c | 21 +++++++++++----------
 1 file changed, 11 insertions(+), 10 deletions(-)

diff --git a/drivers/thermal/broadcom/brcmstb_thermal.c b/drivers/thermal/broadcom/brcmstb_thermal.c
index 87b8e7a..1919f91 100644
--- a/drivers/thermal/broadcom/brcmstb_thermal.c
+++ b/drivers/thermal/broadcom/brcmstb_thermal.c
@@ -277,22 +277,23 @@ static int brcmstb_set_trips(void *data, int low, int high)
 
 	dev_dbg(priv->dev, "set trips %d <--> %d\n", low, high);
 
-	if (low) {
-		if (low > INT_MAX)
-			low = INT_MAX;
+	/*
+	 * Disable low-temp if "low" is too small. As per thermal framework
+	 * API, we use -INT_MAX rather than INT_MIN.
+	 */
+	if (low <= -INT_MAX) {
+		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_LOW, 0);
+	} else {
 		avs_tmon_set_trip_temp(priv, TMON_TRIP_TYPE_LOW, low);
 		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_LOW, 1);
-	} else {
-		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_LOW, 0);
 	}
 
-	if (high < ULONG_MAX) {
-		if (high > INT_MAX)
-			high = INT_MAX;
+	/* Disable high-temp if "high" is too big. */
+	if (high == INT_MAX) {
+		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_HIGH, 0);
+	} else {
 		avs_tmon_set_trip_temp(priv, TMON_TRIP_TYPE_HIGH, high);
 		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_HIGH, 1);
-	} else {
-		avs_tmon_trip_enable(priv, TMON_TRIP_TYPE_HIGH, 0);
 	}
 
 	return 0;
-- 
2.7.4