[PATCH v5 10/10] net: stmmac: dwmac-sun8i: Handle integrated/external MDIOs

[Andrew Lunn]

> +#define DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID	0
> +#define DWMAC_sUN8I_MDIO_MUX_EXTERNAL_ID	1
>  
>  /* H3/A64 specific bits */
>  #define SYSCON_RMII_EN		BIT(13) /* 1: enable RMII (overrides EPIT) */
> @@ -634,6 +639,76 @@ static int sun8i_dwmac_reset(struct stmmac_priv *priv)
>  	return 0;
>  }
>  
> +/* MDIO multiplexing switch function
> + * This function is called by the mdio-mux layer when it thinks the mdio bus
> + * multiplexer needs to switch.
> + * 'current_child' is the current value of the mux register
> + * 'desired_child' is the value of the 'reg' property of the target child MDIO
> + * node.
> + * The first time this function is called, current_child == -1.
> + * If current_child == desired_child, then the mux is already set to the
> + * correct bus.
> + *
> + * Note that we do not use reg/mask like mdio-mux-mmioreg because we need to
> + * know easily which bus is used (reset must be done only for desired bus).
> + */
> +static int mdio_mux_syscon_switch_fn(int current_child, int desired_child,
> +				     void *data)
> +{
> +	struct stmmac_priv *priv = data;
> +	struct sunxi_priv_data *gmac = priv->plat->bsp_priv;
> +	u32 reg, val;
> +	int ret = 0;
> +	bool need_reset = false;
> +
> +	if (current_child ^ desired_child) {
> +		regmap_read(gmac->regmap, SYSCON_EMAC_REG, &reg);
> +		switch (desired_child) {
> +		case DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID:
> +			dev_info(priv->device, "Switch mux to internal PHY");
> +			val = (reg & ~H3_EPHY_MUX_MASK) | H3_EPHY_SELECT;
> +			if (gmac->use_internal_phy)
> +				need_reset = true;
> +			break;

This i don't get. Why do you need use_internal_phy? Isn't that
implicit from DWMAC_sUN8I_MDIO_MUX_INTERNAL_ID? Is it even possible to
use an external PHY on the internal MDIO bus?

> +		case DWMAC_sUN8I_MDIO_MUX_EXTERNAL_ID:
> +			dev_info(priv->device, "Switch mux to external PHY");
> +			val = (reg & ~H3_EPHY_MUX_MASK) | H3_EPHY_SHUTDOWN;
> +			if (!gmac->use_internal_phy)
> +				need_reset = true;
> +			break;

And is it possible to use the internal PHY on the external bus?

    Andrew