[PATCH v2 2/2] ARM: dts: sun8i: h3: Improved Wifi bindings on Bananapi M2 Plus

Philipp Rossak embed3d at gmail.com
Mon Sep 4 06:52:36 PDT 2017


Hi Maxime

Am 04.09.2017 um 10:05 schrieb Maxime Ripard:
> Hi Philipp,
> 
> On Fri, Sep 01, 2017 at 06:30:01PM +0200, Philipp Rossak wrote:
>> From: Philipp Rossak <embed3d at gmail.com>
>>
>> * vqmmc is in this case not needed
>> * no need for pincontrol nodes when the pin is set to a GPIO
>>
>> Signed-off-by: Philipp Rossak <embed3d at gmail.com>
>> ---
>>   arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 7 -------
>>   1 file changed, 7 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
>> index d756ff8..f7e5d8a 100644
>> --- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
>> +++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
>> @@ -98,7 +98,6 @@
>>   	wifi_pwrseq: wifi_pwrseq {
>>   		compatible = "mmc-pwrseq-simple";
>>   		pinctrl-names = "default";
>> -		pinctrl-0 = <&wifi_en_bpi_m2p>;
>>   		reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
>>   	};
>>   };
>> @@ -153,7 +152,6 @@
>>   	pinctrl-names = "default";
>>   	pinctrl-0 = <&mmc1_pins_a>;
>>   	vmmc-supply = <&reg_vcc3v3>;
>> -	vqmmc-supply = <&reg_vcc3v3>;
> 
> So we actually need this one.
> 
>>   	mmc-pwrseq = <&wifi_pwrseq>;
>>   	bus-width = <4>;
>>   	non-removable;
>> @@ -200,11 +198,6 @@
>>   		pins = "PL3";
>>   		function = "gpio_in";
>>   	};
>> -
>> -	wifi_en_bpi_m2p: wifi_en_pin {
>> -		pins = "PL7";
>> -		function = "gpio_out";
>> -	};
> 
> And there's also other GPIO pins here, I'd prefer if you could tackle
> them all at once.
> 
> Thanks!
> Maxime
> 
Thanks for the feedback!
I will fix that with a new single Patch in the next Days.

Philipp



More information about the linux-arm-kernel mailing list