[RESEND PATCH v4 0/2] add thermal nodes for UniPhier SoCs

[Kunihiko Hayashi]

This series adds thermal nodes for UniPhier PXs2 and LD20 SoCs.

Resending the patches to apply the missing comments,
please ignore previous v4.

Changes since v3:
- use the dt-bindings header to replace the limit values with THERMAL_NO_LIMIT
- add the calibration value to uniphier-pxs2.dtsi
- move the calibration value to uniphier-ld20.dtsi

Changes since v2:
- add the calibration value to device tree for LD20 reference board

Changes since v1:
- separate from driver's patchset[1]
- add cooling-maps nodes on the device tree
- fix an interrupt trigger to set 'level-triggered' according to
  hardware specification
- bring up threshold temperature for LD20 according to the spec sheet
- add cpuN labels for reference in cooling-device property on PXs2 dts

[1] https://lkml.org/lkml/2017/6/28/170

Kunihiko Hayashi (2):
  ARM: dts: uniphier: add nodes of thermal monitor and thermal zone for
    PXs2
  arm64: dts: uniphier: add nodes of thermal monitor and thermal zone
    for LD20

 arch/arm/boot/dts/uniphier-pxs2.dtsi             | 47 ++++++++++++++++++++++--
 arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 45 +++++++++++++++++++++++
 2 files changed, 88 insertions(+), 4 deletions(-)

-- 
2.7.4