[PATCH v5] ARM: dts: imx53-tx53: Fix 'ethernet-phy at 0' node with unit name and no reg property

[Fabio Estevam]

On Thu, Oct 26, 2017 at 1:25 PM, Marco Franchi <marco.franchi at nxp.com> wrote:
> The following build warning is seen with W=1:
>
> Warning (unit_address_vs_reg): Node /soc/aips at 60000000/ethernet at 63fec000/ethernet-phy at 0 has a unit name, but no reg property
>
> Fix this warning by adding reg property from such node and, consequently,
> includes a mdio node into the fec node, with the 'address-cells' and
> 'size-cells' to avoid these other following warnings:
>
> Warning (reg_format): "reg" property in /soc/aips at 60000000/ethernet at 63fec000/ethernet-phy at 0 has invalid length (4 bytes) (#address-cells == 2, #size-cells == 1)
> Warning (avoid_default_addr_size): Relying on default #address-cells value for /soc/aips at 60000000/ethernet at 63fec000/ethernet-phy at 0
> Warning (avoid_default_addr_size): Relying on default #size-cells value for /soc/aips at 60000000/ethernet at 63fec000/ethernet-phy at 0
>
> Signed-off-by: Marco Franchi <marco.franchi at nxp.com>

Lothar, could you please test it?

> ---
> Change since v4:
> -pass the 'address-cells' and 'size-cells' values using a mdio node
> -change message log
>  arch/arm/boot/dts/imx53-tx53.dtsi | 14 ++++++++++----
>  1 file changed, 10 insertions(+), 4 deletions(-)
>
> diff --git a/arch/arm/boot/dts/imx53-tx53.dtsi b/arch/arm/boot/dts/imx53-tx53.dtsi
> index 71b58b6..a22e461 100644
> --- a/arch/arm/boot/dts/imx53-tx53.dtsi
> +++ b/arch/arm/boot/dts/imx53-tx53.dtsi
> @@ -225,10 +225,16 @@
>         mac-address = [000000000000]; /* placeholder; will be overwritten by bootloader */
>         status = "okay";
>
> -       phy0: ethernet-phy at 0 {
> -               interrupt-parent = <&gpio2>;
> -               interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
> -               device_type = "ethernet-phy";
> +       mdio {
> +               #address-cells = <1>;
> +               #size-cells = <0>;
> +
> +               phy0: ethernet-phy at 0 {
> +                       reg = <0>;
> +                       interrupt-parent = <&gpio2>;
> +                       interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
> +                       device_type = "ethernet-phy";
> +               };
>         };
>  };
>
> --
> 2.7.4
>