[PATCH v3 0/2] Add Combo PHY driver for HiSilicon STB SoCs

[Shawn Guo]

From: Shawn Guo <shawn.guo at linaro.org>

It adds device tree bindings and driver support for Combo PHY device
which can be found on HiSilicon STB SoCs.

Changes for v3:
 - Make combphy device be child of peripheral controller and use 'reg'
   property for mapping combphy configuration registers.
 - Kill "hisilicon,peripheral-syscon" property, since parent node is
   just the syscon controller now.
 - Check combphy id to handle the quirk that combphy0 can not configure
   mode but always works in USB3 mode.
 - Unify phy .init and .exit hooks for different combphy instances and
   work modes, as the only quirk we need to handle is that combphy0 can
   only work in USB3 mode.
 - Better naming for clock and reset, 'ref' to 'ref_clk', 'por' to
   'por_rst'.

Changes for v2:
 - Move DT bindings into a separate patch.
 - Drop the spurious newline from drivers/phy/Makefile.
 - Use the phy type defines in dt-bindings/phy/phy.h.
 - Use PTR_ERR_OR_ZERO() for checking return from
   devm_of_phy_provider_register().
 - Add USB3 phy support.

Jianguo Sun (2):
  dt-bindings: add bindings doc for hi3798cv200 combphy
  phy: add combo phy driver for HiSilicon STB SoCs

 .../bindings/phy/phy-hi3798cv200-combphy.txt       |  50 ++++
 drivers/phy/hisilicon/Kconfig                      |   9 +
 drivers/phy/hisilicon/Makefile                     |   1 +
 drivers/phy/hisilicon/phy-histb-combphy.c          | 253 +++++++++++++++++++++
 4 files changed, 313 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/phy-hi3798cv200-combphy.txt
 create mode 100644 drivers/phy/hisilicon/phy-histb-combphy.c

-- 
1.9.1