[RFC 2/3] USB: dwc3: Modify dwc3 code for support usb of Hikey960

[Chen Yu]

Hi, Felipe


 On 2017/10/24 16:25, Felipe Balbi wrote:
> Hi,
>
> Yu Chen <chenyu56 at huawei.com> writes:
>> > The usb controller of Kirin960 is DesignWare Cores SuperSpeed USB 3.0 Controller.
>> > The patch modifies dwc3 for support Kirin960 and adds codes for a USB Hub on board Hikey960.
>> >
>> > Signed-off-by: Yu Chen 
> <chenyu56 at huawei.com>
> > Signed-off-by: Ning Fan <fanning4 at hisilicon.com>
> > Signed-off-by: Di Yang <yangdi10 at hisilicon.com>
> > Signed-off-by: Rui Li <lirui39 at hisilicon.com>
> I think Linaro, recently, added support for chargers to mainline. You
> should use what they did.
>
> I'm gonna stop here. There's no way I'm going through this much code in
> a single patch. Specially since 90% of it is either completely
> unnecessary or should be done using already-existing generic APIs.
>
> Sorry, no cookie today.

 Thanks a lot for your comments!
 These codes have been tested on Hikey960 board and work well. But indeed the codes can be simplified and
 made comply with already-existing architecture.
 We will work on these codes according to your reviews and make parted patch next time.

 Thanks,
 Yu Chen