[RESEND PATCH v4 0/2] add thermal nodes for UniPhier SoCs

[Masahiro Yamada]

2017-09-18 21:10 GMT+09:00 Masahiro Yamada <yamada.masahiro at socionext.com>:
> 2017-09-04 15:58 GMT+09:00 Kunihiko Hayashi <hayashi.kunihiko at socionext.com>:
>> This series adds thermal nodes for UniPhier PXs2 and LD20 SoCs.
>>
>> Resending the patches to apply the missing comments,
>> please ignore previous v4.
>>
>> Changes since v3:
>> - use the dt-bindings header to replace the limit values with THERMAL_NO_LIMIT
>> - add the calibration value to uniphier-pxs2.dtsi
>> - move the calibration value to uniphier-ld20.dtsi
>>
>> Changes since v2:
>> - add the calibration value to device tree for LD20 reference board
>>
>> Changes since v1:
>> - separate from driver's patchset[1]
>> - add cooling-maps nodes on the device tree
>> - fix an interrupt trigger to set 'level-triggered' according to
>>   hardware specification
>> - bring up threshold temperature for LD20 according to the spec sheet
>> - add cpuN labels for reference in cooling-device property on PXs2 dts
>>
>> [1] https://lkml.org/lkml/2017/6/28/170
>>
>> Kunihiko Hayashi (2):
>>   ARM: dts: uniphier: add nodes of thermal monitor and thermal zone for
>>     PXs2
>>   arm64: dts: uniphier: add nodes of thermal monitor and thermal zone
>>     for LD20
>>
>>  arch/arm/boot/dts/uniphier-pxs2.dtsi             | 47 ++++++++++++++++++++++--
>>  arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 45 +++++++++++++++++++++++
>>  2 files changed, 88 insertions(+), 4 deletions(-)
>>
>
> Series, applied to linux-uniphier.  Thanks!
>
> --
> Best Regards
> Masahiro Yamada


Both of the patches added W=2 warnings by '_' in the node names.

I fixed them up locally, per Rob's comment:
https://patchwork.kernel.org/patch/9988355/



-- 
Best Regards
Masahiro Yamada