[PATCH net-next v2 2/2] net: ethernet: socionext: add AVE ethernet driver
Masahiro Yamada
yamada.masahiro at socionext.com
Sun Oct 15 08:08:21 PDT 2017
2017-10-13 9:35 GMT+09:00 Kunihiko Hayashi <hayashi.kunihiko at socionext.com>:
> +static int ave_probe(struct platform_device *pdev)
> +{
> + struct device *dev = &pdev->dev;
> + struct device_node *np = dev->of_node;
> + u32 ave_id;
> + struct ave_private *priv;
> + const struct ave_soc_data *data;
> + phy_interface_t phy_mode;
> + struct net_device *ndev;
> + struct resource *res;
> + void __iomem *base;
> + int irq, ret = 0;
> + char buf[ETHTOOL_FWVERS_LEN];
> + const void *mac_addr;
> +
> + data = of_device_get_match_data(dev);
> + if (WARN_ON(!data))
> + return -EINVAL;
> +
> + phy_mode = of_get_phy_mode(np);
> + if (phy_mode < 0) {
> + dev_err(dev, "phy-mode not found\n");
> + return -EINVAL;
> + }
> + if ((!phy_interface_mode_is_rgmii(phy_mode)) &&
> + phy_mode != PHY_INTERFACE_MODE_RMII &&
> + phy_mode != PHY_INTERFACE_MODE_MII) {
> + dev_err(dev, "phy-mode is invalid\n");
> + return -EINVAL;
> + }
> +
> + irq = platform_get_irq(pdev, 0);
> + if (irq < 0) {
> + dev_err(dev, "IRQ not found\n");
> + return irq;
> + }
> +
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> + base = devm_ioremap_resource(dev, res);
> + if (IS_ERR(base))
> + return PTR_ERR(base);
> +
> + /* alloc netdevice */
> + ndev = alloc_etherdev(sizeof(struct ave_private));
> + if (!ndev) {
> + dev_err(dev, "can't allocate ethernet device\n");
> + return -ENOMEM;
> + }
> +
> + ndev->netdev_ops = &ave_netdev_ops;
> + ndev->ethtool_ops = &ave_ethtool_ops;
> + SET_NETDEV_DEV(ndev, dev);
> +
> + /* support hardware checksum */
> + ndev->features |= (NETIF_F_IP_CSUM | NETIF_F_RXCSUM);
> + ndev->hw_features |= (NETIF_F_IP_CSUM | NETIF_F_RXCSUM);
> +
> + ndev->max_mtu = AVE_MAX_ETHFRAME - (ETH_HLEN + ETH_FCS_LEN);
> +
> + /* get mac address */
> + mac_addr = of_get_mac_address(np);
> + if (mac_addr)
> + ether_addr_copy(ndev->dev_addr, mac_addr);
> +
> + /* if the mac address is invalid, use random mac address */
> + if (!is_valid_ether_addr(ndev->dev_addr)) {
> + eth_hw_addr_random(ndev);
> + dev_warn(dev, "Using random MAC address: %pM\n",
> + ndev->dev_addr);
> + }
> +
> + priv = netdev_priv(ndev);
> + priv->base = base;
> + priv->irq = irq;
> + priv->ndev = ndev;
> + priv->msg_enable = netif_msg_init(-1, AVE_DEFAULT_MSG_ENABLE);
> + priv->phy_mode = phy_mode;
> + priv->data = data;
> +
> + if (IS_DESC_64BIT(priv)) {
> + priv->desc_size = AVE_DESC_SIZE_64;
> + priv->tx.daddr = AVE_TXDM_64;
> + priv->rx.daddr = AVE_RXDM_64;
> + } else {
> + priv->desc_size = AVE_DESC_SIZE_32;
> + priv->tx.daddr = AVE_TXDM_32;
> + priv->rx.daddr = AVE_RXDM_32;
> + }
> + priv->tx.ndesc = AVE_NR_TXDESC;
> + priv->rx.ndesc = AVE_NR_RXDESC;
> +
> + u64_stats_init(&priv->stats_rx.syncp);
> + u64_stats_init(&priv->stats_tx.syncp);
> +
> + /* get clock */
Please remove this super-obvious comment.
> + priv->clk = clk_get(dev, NULL);
Missing clk_put() in the failure path.
Why don't you use devm?
> + if (IS_ERR(priv->clk))
> + priv->clk = NULL;
So, clk is optional, but
you need to check EPROBE_DEFER.
> + /* get reset */
Remove.
> + priv->rst = reset_control_get(dev, NULL);
> + if (IS_ERR(priv->rst))
> + priv->rst = NULL;
reset_control_get() is deprecated. Do not use it in a new driver.
Again, missing reset_control_put(). devm?
The reset seems optional (again, ignoring EPROBE_DEFER)
but you did not use reset_control_get_optional, why?
>From your code, this reset is used as shared.
priv->rst = devm_reset_control_get_optional_shared(dev, NULL);
if (IS_ERR(priv->rst))
return PTR_ERR(priv->rst);
--
Best Regards
Masahiro Yamada
More information about the linux-arm-kernel
mailing list