[PATCH v3 16/22] firmware: arm_scmi: add arm_mhu specific mailbox interface

[Sudeep Holla]

Hi Bjorn,

Thanks for taking a look at this. Much appreciated.

On 12/10/17 22:03, Bjorn Andersson wrote:
> On Fri, Oct 6, 2017 at 6:51 AM, Sudeep Holla <sudeep.holla at arm.com> wrote:
>>
>>
>> On 06/10/17 14:47, Jassi Brar wrote:
>>> On Fri, Oct 6, 2017 at 7:02 PM, Sudeep Holla <sudeep.holla at arm.com> wrote:
> [..]
>>>> Again that's not the point, doorbell is more common feature and that can
>>>> be supported. As SCMI expects doorbell feature in the specification, it
>>>> just need to support that class of controllers.
>>>>
>>> NO.  All SCMI expects is SHMEM and a signal reaching the other end.
>>> The signal mechanism need not necessarily be "doorbell".
>>>
>>
>> Agreed, but creating an abstraction ro do something as generic as
>> doorbell and writing shim layer for each controller to use SCMI also
>> sounds bad.
>>
> 
> In the Qualcomm platform we have a single register that exposes 32
> doorbells, wired to interrupts on the various processors/co-processors
> in the SoC.
> 

It's exactly same even on ARM MHU controller. The hardware provides 32
independent bits in a single register termed as a single physical
channel. We may have 2 -3 instances of it in a platform(secure only,
high priority and a low priority).

However the single register is being used to pass 32-bit data on some
platforms. So we may need to support both modes.

One way to deal with that is to add doorbell support in the driver as I
tried previously. But the mailbox maintainer has expressed concerns on
that and hence I am trying to achieve that with the abstraction as in
this patch.

> There is a handful of different clients each using these doorbells to
> inform the other side that something has happened (often that some
> piece of shared memory has been filled with data). Over the years
> (platforms) this register has moved around as such multiple
> implementations exists.
> 
> You can see an example of this in
> drivers/mailbox/qcom-apcs-ipc-mailbox.c and e.g.
> drivers/rpmsg/qcom_glink_native.c (qcom_glink_rpm.c prior to v4.14).
> 
> 

Thanks for the pointer, I have already looked at these implementations.

> 
> I'm struggling to figure out exactly how your case looks like, but if
> your doorbell exists in only one instance and there is only one client
> then I would suggest that it's overkill to create another driver for
> it.
> 

While I agree with your opinion, the maintainer has concerns on trying
to make this a generic solution.
-- 
Regards,
Sudeep