[PATCH 1/2] hwmon: (jc42) optionally try to disable the SMBUS timeout

[Guenter Roeck]

On 10/13/2017 02:27 AM, Peter Rosin wrote:
> With a nxp,se97 chip on an atmel sama5d31 board, the I2C adapter driver
> is not always capable of avoiding the 25-35 ms timeout as specified by
> the SMBUS protocol. This may cause silent corruption of the last bit of
> any transfer, e.g. a one is read instead of a zero if the sensor chip
> times out. This also affects the eeprom half of the nxp-se97 chip, where
> this silent corruption was originally noticed. Other I2C adapters probably
> suffer similar issues, e.g. bit-banging comes to mind as risky...
> 
> The SMBUS register in the nxp chip is not a standard Jedec register, but
> it is not special to the nxp chips either, at least the atmel chips
> have the same mechanism. Therefore, do not special case this on the
> manufacturer, it is opt-in via the device property anyway.
> 
> Signed-off-by: Peter Rosin <peda at axentia.se>
> ---
>   Documentation/devicetree/bindings/hwmon/jc42.txt |  4 ++++
>   drivers/hwmon/jc42.c                             | 20 ++++++++++++++++++++
>   2 files changed, 24 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/hwmon/jc42.txt b/Documentation/devicetree/bindings/hwmon/jc42.txt
> index 07a250498fbb..f569db58f64a 100644
> --- a/Documentation/devicetree/bindings/hwmon/jc42.txt
> +++ b/Documentation/devicetree/bindings/hwmon/jc42.txt
> @@ -34,6 +34,10 @@ Required properties:
>   
>   - reg: I2C address
>   
> +Optional properties:
> +- smbus-timeout-disable: When set, the smbus timeout function will be disabled.
> +			 This is not supported on all chips.
> +
>   Example:
>   
>   temp-sensor at 1a {
> diff --git a/drivers/hwmon/jc42.c b/drivers/hwmon/jc42.c
> index 1bf22eff0b08..fd816902fa30 100644
> --- a/drivers/hwmon/jc42.c
> +++ b/drivers/hwmon/jc42.c
> @@ -45,6 +45,7 @@ static const unsigned short normal_i2c[] = {
>   #define JC42_REG_TEMP		0x05
>   #define JC42_REG_MANID		0x06
>   #define JC42_REG_DEVICEID	0x07
> +#define JC42_REG_SMBUS		0x22 /* NXP and Atmel, possibly others? */
>   
>   /* Status bits in temperature register */
>   #define JC42_ALARM_CRIT_BIT	15
> @@ -73,6 +74,9 @@ static const unsigned short normal_i2c[] = {
>   #define ONS_MANID		0x1b09  /* ON Semiconductor */
>   #define STM_MANID		0x104a  /* ST Microelectronics */
>   
> +/* SMBUS register */
> +#define SMBUS_STMOUT		BIT(7)  /* SMBus time-out, active low */

Requires bitops.h.

Otherwise looks good, though we'll have to wait for Rob's ack.

Thanks,
Guenter