[PATCH v2 0/4] mmc: sdhci-msm: Corrections to implementation of power irq

[Ulf Hansson]

On 27 September 2017 at 07:34, Vijay Viswanath <vviswana at codeaurora.org> wrote:
> Register writes which change voltage of IO lines or turn the IO bus on/off
> require sdhc controller to be ready before progressing further. Once a
> register write which affects IO lines is done, the driver should wait for
> power irq from controller. Once the irq comes, the driver should acknowledge
> the irq by writing to power control register. If the acknowledgement is not
> given to controller, the controller may not complete the corresponding
> register write action and this can mess up the controller if drivers proceeds
> without power irq completing.
>
> Changes since v1:
>         Patch enabling MMC_IO_ACCESSORS in Kconfig moved up the patch list.
>         Also corrected a mistake in the patch.
>         Removed all ifdef CONFIG_MMC_IO_ACCESSORS since the patches using it
>         will come after MMC_IO_ACCESSORS are enabled.
>         Merged the patches 3 & 4 of earlier series into 1 patch (patch 4 in
>         current series).
>         Corrected a mistake in a comment text in patch 3 of previous series.
>
> Changes since RFC:
>         wait_for_completion_timeout replaced with wait_event_timeout when
>         waiting for power irq.
>         Removed the spinlock within power irq handler and API which waits
>         for power irq.
>         Added comments to sdhci msm register write functions, warning that they
>         can sleep.
>         Sdhci msm register write functions will do a memory barrier before
>         writing to the register if the particular register can trigger
>         power irq.
>         Instead of enabling SDHCI IO ACCESSORS config in arm64/defconfig, it
>         will be selected in mmc/host/Kconfig if the platform is MMC_SDHCI_MSM.
>
> Sahitya Tummala (1):
>   mmc: sdhci-msm: Fix HW issue with power IRQ handling during reset
>
> Subhash Jadavani (1):
>   mmc: sdhci-msm: fix issue with power irq
>
> Vijay Viswanath (2):
>   mmc: Kconfig: Enable CONFIG_MMC_SDHCI_IO_ACCESSORS
>   mmc: sdhci-msm: Add sdhci msm register write APIs which wait for pwr
>     irq
>
>  drivers/mmc/host/Kconfig     |   1 +
>  drivers/mmc/host/sdhci-msm.c | 235 ++++++++++++++++++++++++++++++++++++++++++-
>  2 files changed, 231 insertions(+), 5 deletions(-)
>

Thanks, applied for next!

Kind regards
Uffe