[PATCH][v2] dt-bindings: ifc: Update endianness usage

[Prabhakar Kushwaha]

IFC controller version < 2.0 support IFC register access as
big endian. These controller version also require IFC NOR signals to
be connected in reverse order with NOR flash.

IFC >= 2.0 is other way around.

So updating IFC binding to take care of both using endianness field.

Signed-off-by: Prabhakar Kushwaha <prabhakar.kushwaha at nxp.com>
---
Changes for v2: updated subject

 Documentation/devicetree/bindings/memory-controllers/fsl/ifc.txt | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/memory-controllers/fsl/ifc.txt b/Documentation/devicetree/bindings/memory-controllers/fsl/ifc.txt
index 89427b0..824a2ca 100644
--- a/Documentation/devicetree/bindings/memory-controllers/fsl/ifc.txt
+++ b/Documentation/devicetree/bindings/memory-controllers/fsl/ifc.txt
@@ -18,8 +18,10 @@ Properties:
               interrupt (NAND_EVTER_STAT).  If there is only one,
               that interrupt reports both types of event.
 
-- little-endian : If this property is absent, the big-endian mode will
-                  be in use as default for registers.
+- little-endian or big-endin : It represents how IFC registers  to be accessed.
+			It also represents connection between controller and
+			NOR flash. If this property is absent, the big-endian
+			mode will be in use as default.
 
 - ranges : Each range corresponds to a single chipselect, and covers
            the entire access window as configured.
-- 
1.9.1