[PATCH v3 2/4] net: nb8800: Simplify nb8800_pause_config()

[Marc Gonzalez]

On 15/11/2017 15:17, Andrew Lunn wrote:

> nb8800_link_reconfigure() can be called whenever the link to the peer
> changes. auto-neg may happen later because the cable was not plugged
> in until later, etc.

Hello Andrew,

AFAICS, Mans was right: trying to toggle the flow control bit when
the RX DMA bit is already set "breaks" the HW (ping times out).

Thus, I will drop patch 2/4.

In our local branch, I have completely disabled flow control support,
so I don't have to worry about this problem.

Regards.