[PATCH v3 1/4] net: nb8800: Drop generic support

[Marc Gonzalez]

On 14/11/2017 13:37, Måns Rullgård wrote:

> Marc Gonzalez writes:
> 
>> According to our HW dev, there is no provision for software to safely
>> disable RX DMA in the AU-NB8800 hardware block (ethernet DMA). Thus,
>> it is the responsibility of the SoC designer to provide such a feature.
>>
>> The nb8800_dma_stop() implementation is a clever hack that works most
>> of the times, but it breaks the DMA state machine in rare cases.
>>
>> Therefore, let's drop generic support.
>>
>> FWIW, tango chips provide a reset register. When the ethernet block
>> comes out of reset, DMA is disabled.
>>
>> Signed-off-by: Marc Gonzalez <marc_gonzalez at sigmadesigns.com>
>> ---
>>  drivers/net/ethernet/aurora/nb8800.c | 3 ---
>>  1 file changed, 3 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/aurora/nb8800.c b/drivers/net/ethernet/aurora/nb8800.c
>> index e94159507847..26f719e2d6ca 100644
>> --- a/drivers/net/ethernet/aurora/nb8800.c
>> +++ b/drivers/net/ethernet/aurora/nb8800.c
>> @@ -1335,9 +1335,6 @@ static const struct nb8800_ops nb8800_tango4_ops = {
>>  };
>>
>>  static const struct of_device_id nb8800_dt_ids[] = {
>> -	{
>> -		.compatible = "aurora,nb8800",
>> -	},
>>  	{
>>  		.compatible = "sigma,smp8642-ethernet",
>>  		.data = &nb8800_tangox_ops,
>> -- 
> 
> Please leave this.  It works just fine on tango3.

What you call "tango3" is your SMP8642-based board, I suppose.
That is covered by the "sigma,smp8642-ethernet" string.

There is no need for the generic "aurora,nb8800" string, as no other
known SoC uses the Aurora SSN8800+NB8800 IP; and as I point out in the
commit message, the raw IP lacks certain features.

There is no point in keeping this around. It just adds unnecessary
existence tests for every use of the ops struct.