[linux-sunxi] Re: [PATCH] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board

[Maxime Ripard]

Hi,

On Fri, Nov 03, 2017 at 07:53:17AM +0800, Icenowy Zheng wrote:
> 在 2017-11-02 23:50，Maxime Ripard 写道：
> > On Thu, Nov 02, 2017 at 05:07:30PM +0800, Icenowy Zheng wrote:
> > > > > +&mmc0 {
> > > > > +	pinctrl-names = "default";
> > > > > +	pinctrl-0 = <&mmc0_pins_a>;
> > > > > +	vmmc-supply = <&reg_vcc3v3>;
> > > > > +	bus-width = <4>;
> > > > > +	/*
> > > > > +	 * In different revisions the board have different card detect
> > > > > +	 * configuration.
> > > > > +	 */
> > > >
> > > > Which ones?
> > > 
> > > In the sample batch (1.2V fixed voltage) the card detect is normal
> > > (PF6 low as inserted), however in the final batch (1.1V/1.3V
> > > switchable) it's inverted at PF6 (high as inserted).
> > 
> > Then just use the final version's.
> > 
> > > > > +&usbphy {
> > > > > +	usb0_id_det-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
> > > > > +	/* USB OTG VBUS is directly connected to 5V without any regulators
> > > > > */
> > > >
> > > > So it cannot operate in OTG, but it's host only?
> > > 
> > > It can operate in OTG -- you can power the board via the OTG port,
> > > as the VBUS is not gated from 5V at all, so 5V power at VBUS will
> > > power up the board. Yes, it's a bit unsafe, but the board designer
> > > did it.
> > 
> > What will provide the 5v in the first place then if a USB device is
> > connected to the micro-USB connector?
> 
> There're two micro-USB connectors, one is power-only and another is
> OTG. The Vbus of these two connectors are connected together, so
> the external USB device will be powered just by the power input
> from the power-only USB port.

Can you put that in the comment?

Thanks.

Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 801 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20171113/84de0ec9/attachment.sig>